Three-Station Car Lamp Production And Assembly Equipment Line – 3D Model SolidWorks

This is a set of equipment for producing car lights. It can complete the assembly of car lights (Fender and Trunk car lights) through electric and gas drive and manual work. It is a set of non-standard equipment. (However, other car light products can be produced by changing the clamping tooling and running PLC. It is a very good reference material for those who need to design car light assembly equipment) This set of equipment is divided into three stations. The ST09 station installs the fixing screws, semi-permeable membrane, and gasket to the lamp housing; the ST12 station wraps the protective film and scans the label; the ST13 station sticks the barcode to the whole box.
ST09 station operation process description: 1. Take the semi-finished product and put it on the corresponding tooling, clamp the tooling to lock the product;
2. Take the fixing screws and install them on the lamp housing;
3. Take the semi-permeable membrane and gasket and install them on the lamp housing;
4. Remove the model and put it on the next station.
ST12 station operation flow description: 1. Take the product and put it on the tooling;
2. Check the appearance, clean, and dot;
3. Wrap the protective film;
4. Scan the label information.
ST13 station operation flow description: 1. Take the product and put it on the work surface;
2. Check the appearance, light up, and dot;
3. Pack;
4. Print the barcode on the barcode printer and stick it on the whole box packaging.