Polymer Battery Shaping Labeling Machine – 3D Model SolidWorks

This equipment is a special equipment for shaping, gluing and labeling of soft-pack polymer batteries. The battery is manually placed on the pull line and the start button is pressed. The equipment starts and enters the battery anti-reverse CCD test station. After CCD inspection, if it is normal, it will flow directly into the equipment through the dust removal mechanism. If the battery is reversed, the equipment alarms and the battery is manually corrected and the start button is pressed again. The battery flows into the equipment through the dust removal mechanism. The loading and unloading manipulators pick up the battery and move it to the shaping mechanism to shape both sides of the battery, and then perform CCD inspection. Then it is taken to the positioning labeling fixture, and the motor drives the fixture to move backward to the labeling position. The label feeding feeder peels off the label. The X, Y, Z, W four-axis manipulator picks up the label, and the CCD visual detects the label position. The information is transmitted to the system, and the system instructs the X, Y, Z, W four-axis manipulator to correct the deviation position. The manipulator moves to the labeling position. Stick the label on the battery. The shaping station returns to the designated position, the labeling mechanism releases the Z-axis cylinder to lift the battery upward, the rollers on both sides wrap the two sides of the battery, and the folding robot grabs the battery and transfers it to the folding station. First, use the roller to roll the battery tab glue flat, and then fold the tab edge after the CCD visual inspection is OK, and then fold the bottom two tabs and finally fold the bottom edge. After completion, the robot transfers the battery to the unloading pull line. SOLIDWORKS 2018 design