Non-Standard Automation Flat Line Cut-Off Inspection Machine SolidWorks 3D Model

Flat wire cut inspection machine, FFC flat wire cut CCD inspection machine n I. Equipment Description This equipment applies to the following products: length 200mm, width 6 ~ 30mm flat line; robot repeat positioning accuracy: ≤ ± 0.01 mm 4. Inspection content: a: Appearance inspection b: cut off the size of the metal conductor, metal line center line spacing, metal line to the edge of the line distance, reinforcement plate can be detected. Detection accuracy can be plus or minus 0.05mm. The equipment is FFC wiring processing equipment: equipment for the tray loading mode of operation, manpower only need to put the FFC to material material on the material rack can be, the equipment automatically feed according to the set length of the cut, cut the material accuracy of up to 0.01, the length of the wire processing also needs to be further testing of the CCD vision system, the equipment has a simple structure and precision, the pick-up robot and the material robot synchronized work, the detection of good products sucked into the detection platform. Detected products sucked into the detection platform, the detection platform for the vacuum suction plate to do, when the detection of OK robot to put the product into the lower material conveyor belt stacked under the material, the number of each stack is also in accordance with the value set by the customer for the operation of the manual only in the conveyor belt where the material can be collected, the above equipment, the overall action of the principle of welcome to download and learn if you like. Main Technical Parameters: Category Specifications Dimensions: 1850 * 1000 * 1800MM (L * W * H) Input Voltage: AC-220V50Hz or AC-380V 50Hz optional Maximum Power: 0.8K W (220V) Input Air Pressure: 0.4-0.6 Mpa Air Consumption: 1.5KW (0.5KW) Mpa gas consumption: 1.5 L/min Production efficiency (C/T): ≤ 2.8 S / a equipment load factor: ≥ 95% to adapt to the product specifications: length of 200mm or less, the width of 6 ~ 30mm flat line; robot repetitive positioning accuracy: ≤ ± 0.01 mm Inspection content: a: Appearance detection b: cut off the metal conductor size, metal line center line spacing, metal line to the edge distance, the reinforcement plate, etc. can be detected. Reinforcement plate can be detected. Detection accuracy can be plus or minus 0.05mm