Non-Standard 18650 Battery Cell Automatic Peeling Machine, 18650 Cylindrical Battery Peeling Equipment – 3D Model SolidWorks

Machine name: 18650 cylindrical battery cell automatic cutting and peeling equipment. Introduction to equipment working principle. The products suitable for this equipment are: 18650 battery cell, 26650, cylindrical mobile power battery, automobile power battery and other cylindrical battery core peeling. This equipment is mainly an automatic peeling and loading equipment for new energy power batteries: the full set of drawings is more than 100 MB after decompression, and the switchboard has more than 200 parts. The equipment mainly peels cylindrical cells through a hot method. First, the cells are manually peeled. The core is put into the feeding conveyor belt, and the robot grabs the electric core and enters the peeling section conveyor belt. It chooses which conveyor belt to put into according to the production speed. The electric core enters the peeling jig through the conveyor belt. When the battery enters the cutter jig, the cutter rotates, and the cell structure clamps the cell. The cutter cuts the skin of the cell, and then the scrap manipulator clamps the peeled green paper, which is what we call it. Scrap and peeled electric cores are automatically sent out from the discharging conveyor belt, and the materials can be collected and packed manually. The principle of peeling is that the stepper motor drives the cutter fixture to rotate when the electric core remains stationary. It rotates at high speed and cuts the outer skin of the battery in the heating state. The cutting accuracy is 0.1MM. The equipment has three channels and the production capacity is about 7000-8000 per hour. Therefore, this peeling structure and speed can basically satisfy most customers in the current market. According to the demand, automatic loading and unloading of the front and rear ends of the equipment can be added. Adjust according to the cost, manual or automatic loading and unloading functions. The internal cutter structure pictures can also be seen as relatively complicated. Of course, if you want to know more about the structural design, you need to download it. Then slowly learn, the drawings are complete, friends who are in need or interested are welcome to download and learn. The above is the entire structure and working principle of this equipment. 4. Main technical parameters: Category specification parameters Overall machine dimensions: 1350*1220*1700MM (L*W*H) Input voltage: AC-220V50Hz or AC-380V 50Hz optional Maximum power of the whole machine: 0.9KW (at 220V) Input air source pressure: 0.4-0.6 Mpa Air consumption: 1.5 L/min Production efficiency (C/T): ≤1.0 S/one equipment utilization rate: ≥95% Processing method: automatic detection, automatic peeling, automatic discharging and changing Material method: manual feeding