HW Tablet Dispensing AB Glue Automatic Production Line (Hot Capacitor Dispenser) SolidWorks 3D Model

A very good set of flat-panel electric metal shell dispenser automated production line, the structure and zero design are very good, large and small parts add up to more than 1,000 SW2011 design source files to share There are also STP files, close to 200M, [must be put together to open the two packages of files before the complete]. n Apple tablet PC shell hot capacitive dispensing production line This equipment is mainly for Huawei’s tablet PC back shell dispensing and then turn over the press to point good AB adhesive metal shell and plastic shell pressed together in a number of up to the conveyor line automatically flow to the hot press bit, automatic conveyor line in two stations to hot press, because the hot capacitive time is relatively long with the station to reduce the cycle of hot press, the whole production line is the main principle of work is: manual metal shell into the dispensing fixtures, and the metal shell to the dispensing fixtures. The main working principle of the whole production line is as follows: put the metal shell into the dispensing fixture position, start to dispense the AB glue, turn over after dispensing to let the metal shell and the plastic shell to press together, the conveyor belt sends the running board to the hot pressing position, start to hot press the work, the hot pressing good automatic outflow to the main conveyor belt, from the main conveyor belt to the back-end of the flow to the manual collection of materials, and then the running board flow to the dispensing position again, the manual release of the metal shell and the plastic shell, due to the workstation and the equipment is more complex here is a simple brief introduction. The following is a brief description of the process.