Engine SW Model With Oil Cooler – 3D Model SolidWorks
Solidworks 2012 designed engine with oil cooler 3D model source file sharing!
Including left crankcase, right crankcase, oil pump, left external oil pipe, The right external oil pipe and oil radiator are characterized in that a balance shaft bearing seat is arranged on the right crankcase, an oil inlet hole and an oil outlet hole are arranged on the right crankcase, a first oil channel is arranged below the oil inlet hole, an acute angle between the first oil channel and the vertical direction is 10-20 degrees, the first oil channel is communicated with the oil inlet hole, a first oil plug is arranged at the end of the first oil channel, and an oil hole connected to the oil channel in the right crankcase is arranged on the first oil channel; a second oil channel is arranged on the side of the oil outlet hole in the horizontal direction, the second oil channel is communicated with the oil outlet hole, and a second oil plug is arranged at the end of the second oil channel; a third oil channel is arranged in a direction with an acute angle of 20-45 degrees between the oil outlet hole and the vertical direction, the third oil channel is communicated with the second oil channel, the third oil channel is connected to the right external oil pipe, and the right external oil pipe is connected to the oil radiator; the right crankshaft A fourth oil channel is provided on the outside of the balance shaft bearing seat on the box in a direction at an acute angle of 30-40 degrees with the horizontal direction, and the fourth oil channel is respectively communicated with the second oil channel and the oil groove on the right crankcase; a fifth oil channel is provided above the front lifting hole on the right crankcase in a direction at an acute angle of 30-40 degrees with the horizontal direction, one end of the fifth oil channel is communicated with the oil groove, and the other end is communicated with the sixth oil channel, and a fifth oil plug is provided at the end of the fifth oil channel; a seventh oil channel is provided on the upper left side of the front lifting hole of the left crankcase in a direction at an acute angle of 40-60 degrees with the horizontal direction, the distance between the center of the seventh oil channel and the center of the front lifting hole is 12-20mm, the seventh oil channel is communicated with the eighth oil channel, the eighth oil channel is communicated with the sixth oil channel, and a left external oil pipe is provided at the end of the seventh oil channel, and the left external oil pipe is connected to the oil radiator
Specification: Engine SW Model With Oil Cooler – 3D Model SolidWorks
|
User Reviews
Be the first to review “Engine SW Model With Oil Cooler – 3D Model SolidWorks”
You must be logged in to post a review.
There are no reviews yet.