Copper End Ring Welding Device For Squirrel Cage Rotor SolidWorks 3D Model

(Reproduction is strictly prohibited) The main purpose is that the motor drives the three-jaw chuck to rotate at a constant speed, and then there is a heating ring to heat the rotor to be clamped for welding The working principle is as follows: n Will be ready to weld the copper end ring of the rotor end clamped on the three-jaw chuck, the other end by the floating center for fixed. Fixed after the brazing material evenly coated on both sides of the copper end ring, coated evenly after the start of the motor, the motor drives the V-belt drive, the V-belt connects the bevel gear commutation rotation, the bevel gear drives the three-jaw chuck for uniform speed rotation. After starting the motor, start the induction heating ring located on both sides of the copper end ring for heating, and at the same time start the water-cooled circulating ring located in the induction ring to protect the processed rotor shaft from heat deformation again. The copper end ring is heated uniformly during the rotation of the three-jaw chuck until the whole copper end ring is brazed and welded, then the heating device is turned off, followed by turning off the motor and waiting for the temperature of the welded part to drop to turn off the water-cooled circulating circle. n In addition, in the structural layout, the electric motor is selected to be placed horizontally, the belt drive is connected to the bevel gear, and the bevel gear is reversed to connect the three-jaw chuck to rotate horizontally. The processed workpiece is vertically clamped by the three-jaw chuck, and the upper part is fixed by the top part (reproduction is strictly prohibited)