Car Sunroof GPA Trimming And Polishing Workstation 3D+Engineering Drawing+BOM+Instructions – 3D Model SolidWorks
Car sunroof GPA trimming and grinding workstation
1. Basic functions:
Place the car sunroof GPA and perform trimming and grinding, cleaning inspection, and sealing strip installation operations. The glass can be freely rotated horizontally, turned over (axially 180 degrees), and has a brake function
2. Error prevention function: None
3. Operators
1. Number of operators: 1 person
2. Working posture – standing operation
4. Durability
1. Continuous use time – 24H/day
2. Durability-more than 10 years
V. Capacity
1. Total cycle time-NA
2. Manual operation time-<60sec
3. Product switching tool adjustment time-<1min (only suction cup position adjustment)
VI. Working environment
1. Noise level-below 70dB from the noise source to 1m away
2. Irritating gas-chemical gas such as butanone is discharged from the air duct
VII. Power specifications
1. Power specifications-3-phase 380V 50Hz or single-phase 220V 50Hz
2. Air source specifications- 6±1Kg/cm2
VIII. Quality
1. Failure rate-no unexplained equipment problems caused by defects.
2.Precision requirements--Dimensions must be ≤±10mm
Specification: Car Sunroof GPA Trimming And Polishing Workstation 3D+Engineering Drawing+BOM+Instructions – 3D Model SolidWorks
|
User Reviews
Be the first to review “Car Sunroof GPA Trimming And Polishing Workstation 3D+Engineering Drawing+BOM+Instructions – 3D Model SolidWorks”
You must be logged in to post a review.
There are no reviews yet.