Automatic Stator Shaft Assembly Line, Large Non-Standard Assembly Line SolidWorks 3D Model

Automatic stator shaft assembly line, the model contains engineering drawings, and the list bom is a large non-standard assembly line, automated non-standard assembly line of various complex parts. n Non-standard automatic production line automatic stator shaft assembly line working principle and action sequence: nA, Specialized tooling board enters the tooling board stack storage area from the lifting platform. nB, When the tooling board for BMC stator is empty, the tooling board enters the station from the stack storage area. (The blocker blocks the board and the board stops, the same below) The manipulator puts the BMC stator (2 sets) into the corresponding position of the dedicated board, steps on the foot switch, and the board goes down and enters the next stack storage area. nC, When the station for placing rotor, PG plate and BB cover is empty, the tooling board automatically enters the station, then step on the foot switch, the board automatically runs to the next station staging area. nD, When the station for pressing BB cover is empty, the tooling board automatically enters into the station to press BB cover automatically to detect the tampering amount, etc. After pressing, then step on the foot switch, the tooling board will automatically run to the next station for storing. nE, When the performance testing station is empty, the board will automatically run to this station to test the performance manually, after the performance testing is completed, then step on the foot switch, the board will automatically run to the board lifting platform stack storage area. nF, Execute the next cycle. n3, The total length of the line body is 5 meters (including the lifting platform at both ends) (subject to actual design), the total width is 300mm (subject to design dimensions) (excluding the protruding part of the lifting platform at both ends), the height of the upper layer containing the work plate is 800 mm (subject to actual design), and the height between the two layers is 400mm (subject to actual design). The height of the supporting tripod of the wire body is adjustable, with an adjustment range of ±30mm. n4, The line body adopts double-layer return-plate structure, the upper layer is for motor transmission, and the lower layer is for quick return-plate of the work plate. na, The wire body is driven by roller chain; with independent power drive.