Modeling Of Telescopic Belt Line And Two-Section Telescopic 4.5m Belt Line – 3D Model SolidWorks
[SW2012] Modeling of a two-section telescopic 4.5-meter belt line based on SW. The modeling is detailed, realistic, and has a detailed three-dimensional design. The source file is included for everyone to share! The principle of the telescopic belt conveyor: The principle of the telescopic belt conveyor is actually very simple. The telescopic principle is similar to the drawer principle, but the extraction structure is slightly different. The belt is wrapped around each drawer to change the conveying length while keeping the total length of the belt unchanged. Of course, it is easy to say, but it is still quite difficult to do it. The design of the telescopic conveyor should pay special attention to the load-bearing capacity of the frame, the strength and wear resistance of the sliding track, as well as the processing accuracy during processing and the matching accuracy of each part. Telescopic belt line
Specification: Modeling Of Telescopic Belt Line And Two-Section Telescopic 4.5m Belt Line – 3D Model SolidWorks
|
User Reviews
Be the first to review “Modeling Of Telescopic Belt Line And Two-Section Telescopic 4.5m Belt Line – 3D Model SolidWorks”
You must be logged in to post a review.
There are no reviews yet.