SMT Online ICT And FCT Double-Layer Multifunctional Automatic Testing Machine Equipment – 3D Model SolidWorks

The SMT online iCT and FCT double-layer automatic tester is a multifunctional fully automatic ICT and FCT tester. The equipment is a multifunctional tester that can be operated online or offline. The functional principle is: the PCB board enters the tester from the docking station and the sensor detects the presence of the board. The conveyor cylinder in the equipment drives the entire belt line and the PCB to descend to the test needle plate at the bottom so that all the solder joints of the PCB board contact the probe to start the test. At the same time, the cylinder above the PCB board also descends to press the board into place for testing. After a few seconds, the test is completed and the cylinder drives the conveyor belt to rise to its original position, indicating that the test is completed. The PCB board begins to flow out to the unloading docking station position, and the unloading board feeding machine starts to collect the material. If a defective product is detected at the front end, the equipment alarms after the board flows out. At this time, the board collection board will not take the board away, and the defective product needs to be taken away manually. The working principle of this equipment is to operate in a cycle here. Other functions include: ICT of PCB circuit FCT bad test, short circuit fault of circuit board, some high voltage test of capacitor and inductor, etc. The line is divided into four sections, namely, PCB loading machine to docking station to send board to line test machine, unloading docking station, unloading machine. The main part is to introduce the tester, because the tester is double-layered, only the bottom layer can work. If the upper layer needs to be used, the front and rear docking stations need to be replaced with elevators to achieve simultaneous operation of the upper and lower layers. The complete model of the equipment + parts BOM is very worth learning.